Preparation : Good preparation is key to a professional looking, long lasting finish.
Precaution : Always test recycled timber for adhesion prior to full application. MICROCLEAR is best used in semi shaded areas.
Tools : Brush, roller (short nap) or spray application.
Application : Refer to Technical Datasheet for full application method.
Ensure the surface is clean, dry and free from all dirt, dust, grease and grime.
Sanding not usually required, however if grain raising occurs de-nib / lightly sand after the first coat.
Interior : Apply 1 to 3 coats to achieve the desired finish.
Exterior : Apply a minimum of 3 coats.
Spraying: Airless spray recommended. Use a 0.33 to 0.38mm (13 – 15 thou) orifice, 10cm fan (dependent on job) with a regulated pump pressure of 350-400 kPa (50 – 55 psi) tip pressure. Back brushing is recommended to achieve an even finish. Use normal protection i.e. mask, overalls. Watch your overspray. Wash off with soap and water before it dries.